Fiberfrax Coating Cements QF-180, QF-180 Blue & QF-150 provide a range of consistencies for brush, spray or trowel applications. They possess good adhesion, thermal reflectance, dielectric strength, hot gas erosion, & effectively resist wetting by many nonferrous molten metals.
Fiberfrax Ridigizer W is an inorganic
liquid hardener that is used to increase the durability of our
ceramic fiber blankets & boards. Fiberfrax Fiberstick is an air
setting mortar used to adhere our ceramic fiber products to
refractory surfaces & is rated to 3000F.
Fiberfrax Topcoats are used as protection
against slag, alkali attack, & flame and hot gas erosion when
applied to our ceramic fiber products. Topcoat 2600 & M are
rated to 2600F, while Topcoat 3000 is rated to 3000F.
Fiberfrax Moldables have a putty-like
consistency & adheres well to most surfaces. Upon drying, the
moldables provide a strong, hard & erosion resistant result.
They can be applied by caulking, troweling, hand forming or pumping.
The LDS-AL possesses excellent resistance to wetting by many
nonferrous molten metals, especially in aluminum contact
applications
Fiberfrax FC-25 Tamping
Mix is a wet mix that can be tamped into place. Fiberfrax
Variform is a dry mix where you can add water on-site, mix &
trowel into place.
Fiberfrax Bulk Fibers are manufactured in various chemistries to have temperature rating of 2300F, 2600F & 3000F. These Bulk Fibers are used as fill & packing insulation in high temperature applications.
These Silicon Carbide Heating
Elements are used in industrial Furnaces & Kilns. They are
available in a straight bar, straight bar with grooves and a single
end bayonet design, all rated at least to 2800F.
The Anchored Modules are secured to the
interior steel shell of the furnace or kiln with our different
attachment methods. The Bonded Modules do not have any
anchor plate, but can be installed to an existing refractory lining
with Fiberstick Mortar to help improve efficiency.